Sticker Care

Stick it right and peel it clean. Here's how to get the most out of your SKREE stickers.

How to Apply

Wipe the surface clean so there's no dust, oil or fingerprints. A little rubbing alcohol works best. Let it dry completely.
Peel the sticker off its backing, holding it by the edges.
Place it where you want it and press down from the centre outwards to push out any air bubbles.
Give it 24 hours to settle before it gets wet or goes near heat.

Best on: smooth, hard surfaces like laptops, phone cases, water bottles, notebooks, helmets and mirrors.
Avoid: fabric, rough or textured surfaces, and freshly painted walls.

How to Remove

Warm the sticker with a hairdryer on a low setting for about 20–30 seconds, keeping it moving. This softens the glue.
Lift one corner with your fingernail. Don't use blades or anything sharp.
Peel slowly, keeping it low and folding it back over itself. If it starts to resist, warm it again for a few seconds.

Some Residue Left Behind?

Our stickers are made to come off clean, but a little residue can happen, especially when:

the sticker has been on for many months
it's been near heat or sunlight (laptop vents, car dashboards, a sunny window)
it was stuck on a rough or porous surface
it was peeled off cold or quickly

To clean it up:

Roll it off with your fingertip. Small bits usually ball up and lift away.
Use a soft cloth with a few drops of rubbing alcohol or coconut oil, then wipe the area clean and dry.
Test on a hidden spot first. Avoid nail polish remover (acetone), harsh chemicals and scrubbers on plastic, painted or coated surfaces like laptop lids.

How cleanly a sticker comes off depends on the surface, how long it's been on, and how much heat or sun it's had.